Rheem 50 Manuel de service télécharger pdf (Page 11)

WATER SUPPLIES

+0.4 +0.80

very corrosive very scaling

scaling

corrosive

-1.0

no warranty applies to a:

temperature pressure relief valve or a

water heater cylinder unless an

expansion control valve is fitted.

no warranty applies to a:

-copper sheathed heating unit

SATURATION INDEX (SI)

ELECTRIC WATER HEATERS

WITHIN WARRANTY

SPECIFICATION

SATURATION INDEX

(calculated @ 80°C water temperature)

no warranty applies to a:

-standard watts density heating unit

SUMMARY OF WATER CHEMISTRY ADVICE AFFECTING WARRANTY

The water heater and its components are not suitable for certain water chemistries. Those chemistries are

listed below. If the water heater is connected at any time to a water supply with the following water chemistry,

the Rheem warranty will not cover any resultant faults on the components listed below:

Water Chemistry

Component

Total Dissolved Solids (TDS) > 2500 mg/L

water heater cylinder

Total Dissolved Solids (TDS) not suitable for anode type

water heater cylinder

Saturation Index (SI) < -1.0

copper sheathed heating unit

Saturation Index (SI) > +0.4

(if expansion control valve is not fitted)

water heater cylinder

temperature pressure relief valve

Saturation Index (SI) > +0.8

standard watts density heating unit

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Pas de commentaire

Rheem 50 Manuel de service Page 11