Rheem Indirect Water Heater Manuel d'utilisateur télécharger pdf

#23960 P1ge 1

WARNING

Improper installation, adjustment, alteration,

service or maintenance can cause serious injury

or property damage. Refer to this manual. For

assistance or additional information, consult a

qualified installer or service agency.

CAUTION

The recommended temperature for normal

residential use is 120°F. The dial on the aquastat

does not always reflect the out-coming water

temperature, which could occasionally exceed

120°F. The variation in out-coming temperature

could be based on factors including but not

limited to usage patterns and type of installation.

Test your water at the tap nearest to the indirect

water heater.

WARNING

Hotter water increases the risk of scald injury.

Before adjusting the water temperature setting,

read this instruction manual. Temperatures at

which injury occurs vary with the person’s age

and the length of exposure.

The slower reaction time of children, elderly, and

physically or mentally challenged persons

increases the scalding hazard to them. It is

recommended that lower water temperatures be

used where these exposure hazards exist. Such

households may require a temperature setting

less than 120°F to prevent accidental contact

with hot water.

To lower water temperature use point-of-use

temperature limiting devices.

WARNING

Water heater blankets are not recommended and

will void the warranty.

THIS MANUAL HAS BEEN PREPARED

TO ACQUAINT YOU WITH THE INSTALLATION,

OPERATION, AND MAINTENANCE OF

YOUR INDIRECT WATER HEATER AND TO PROVIDE

IMPORTANT SAFETY INFORMATION.

INSTALLER RESPONSIBILITIES

Please read all instructions thoroughly before

installing or placing the indirect water heater

into service. This unit must be installed by

licensed or authorized installers, or technical

personnel that service water heating equipment.

The indirect water heater must be installed in

accordance with all local codes and ordinances.

These instructions are a guide for the correct

installation of the indirect water heater. The

manufacturer will not be liable for damages caused

by failure to comply with the installation and

operating instructions outlined on the following

pages.

CAUTION

The recommended water temperature setting for

normal residential use is 120°F/49°C.

HANDLING

Before uncrating, check for shipping damage.

Report any damage to your carrier. Note damage on

bill of lading or delivery receipt and file a claim.

FAILURE TO FOLLOW THESE INSTRUCTIONS OR ALL

APPLICABLE BUILDING CODES AND REGULATIONS

VOIDS THE WARRANTY

ON THIS INDIRECT WATER HEATER.

Read all instructions thoroughly before

attempting installation or operation of your

indirect water heater. Keep these instructions for

future reference.

Local plumbing and electrical codes must be

followed in the installation of this indirect water

heater. In the absence of a local code use the

UNIFORM PLUMBING CODE and the NFPA Code.

Local codes may supersede instructions in this

installation manual.

These instructions are a guide for the correct

installation of the indirect water heater. The

manufacturer will not be liable for damages

caused by failure to comply with the installation

and operating instructions outlined on the

following pages.

Warranty and Parts List are included.

To the Consumer:

Please read these and all component

instructions and keep for future reference.

To the Installer:

Please attach these instructions

next to the indirect water heater.

Indirect Water Heater

Instruction Manual

Rev 1 5/08

1 2 3 4 5 6 ... 15 16

Résumé du contenu

Page 1 - Instruction Manual

#23960 P1ge 1WARNINGImproper installation, adjustment, alteration, service or maintenance can cause serious injury or property damage. Refer to this

Page 2

Page 10 See Figure 8 for piping your Rheem indirect water heater to a low-mass boiler (diagram recommended by boiler manufacturer).SECTION IV: INSTALL

Page 3 - SECTION I: SPECIFICATIONS

ELECTRICAL CONNECTIONSFigures 9 and 10 are general wiring diagrams. For a maintaining temperature boiler, Figure 9 should closely match your system.

Page 4

Page 12 SECTION V: MAINTENANCEWATER PIPINGOn an annual basis, all piping should be checked for leakage at joints, shut-off valves, and unions.T&P

Page 5 - LOCATION

&LUFXODWRUGRHVQRWRSHUDWH&KHFNDTXDVWDWVHWWLQJ352%/(0&$86( 62/87,21%RLOHUGRHVQRWRSHUDWH5HIHUWRERLOHULQVWDOODWLRQLQVWUXFWLRQV&

Page 6 - ANODE RODS

SECTION VII: PARTS LISTNo. Description Applicable Models1 Anode All models.2 Anode Outlet STID 30, STID 40, STID 503 T&P Relief Valve All models.

Page 7 - SECTION III: PRE-INSTALLATION

Page 15LIMITED WARRANTYFor Rheem/Ruud™ Indirect Water Heaters.GENERALThis Limited Warranty is only available to the original owner of this water hea

Page 8 - UP 26-64F

Page 16 EXCLUSIVE WARRANTY – LIMITATION OF LIABILITYThis Limited Warranty is the only Warranty given by the manufacturer, the Rheem Water Heater Opera

Page 9 - SECTION IV: INSTALLATION

Page 2 TABLE OF CONTENTSSection I: Specifications ... 3Section II: General Informations ...

Page 10 - Page 10

Page 3GCold Inlet, 3/4" NPTHot Outlet/Anode Rod,3/4" NPTAnode RodAquastatT&P Relief Va lveFrom Boiler Supply, 1" NPTTo Boiler Re

Page 11 - R845 Relay

Page 4 SECTION I: SPECIFICATIONS (cont.)STID30 30 1.38 110 85 25 55,000 1.3 2.0STID40 38 2.30 153 120 33 77,000 1.1 3.0STID50 45 2.30 160 120 40 77,00

Page 12 - SECTION V: MAINTENANCE

SECTION II: GENERAL INFORMATIONLOCATIONThe indirect water heater should be located in a central location to the piping system, as close as practical t

Page 13 - SECTION VI: TROUBLESHOOTING

Page 6 SECTION II: GENERAL INFORMATION (cont.)ANODE RODSThe anode rod is used as a sacrificial element within the volume of the storage tank. The pur

Page 14 - SECTION VII: PARTS LIST

SECTION III: PRE-INSTALLATIONBOILER AND CIRCULATOR SIZINGThe ratings published in this manual for your Rheem indirect water heater can be obtained thr

Page 15 - Page 15

Page 8 UP 15-42F/FRClosed Systems, 60 HzUP 26-64FClosed Systems, 60 HzSECTION III: PRE-INSTALLATION (cont.)Figure 4: GRUNDFOS UP 15-42F performance

Page 16

BOILERSYSTEMSUPPLYCIRCULATORPUMPBOILERSYSTEMRETURNBOILER COLD1" INLETWATER HEA T ERINDIRECTHOT OUTDOMESTIC1 1/2"BOILERFROMTOBOILERCHECKVA L

Commentaires sur ces manuels

Pas de commentaire

Rheem Indirect Water Heater Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Chaudière à eau Rheem Indirect Water Heater. Rheem Indirect Water Heater User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Chaudière à eau Rheem Indirect Water Heater