Rheem GEN20B Manuel de l'opérateur télécharger pdf (Page 12)

8. Enter the 9-digit Serial Number from the label on the

transmitter (see Controls and Features for location),

following the instructions on the screen. When the last

digit is selected, choose to Synchronize.

9. Select Confirm. After approximately 20 seconds, the

display console will report that the system is

“Synchronized” and return to Idle Mode. Or it may

display a “System Sync Unsuccessful” message and

return to the System Sync Mode. Refer to

Troubleshooting if this message appears.

Viewing the Maintenance Schedules and History

1. From the Main Menu select Maintenance Schedule (see

Figure 7), then select Overview. The display console will

report the time remaining before the next change is

required for Air Cleaner, Oil & Filter, and Spark Plug(s).

Figure 7: Maintenance Menu

2. Select Return, then Return to Previous Menu to reach

the Main Menu.

3. Select History to view the system’s Total Run Time and

the time remaining until the Next Exercise (see

Figure 8).

Figure 8: History Screen

Viewing Outage, Power Mode, and Exercise

When a utility outage occurs, “Utility Power Outage” will be

reported on the display console’s system status readout

instead of “System Ready”. After the standby generator

starts, “Generator Power Mode” will be reported until utility

power is again recognized and the generator first cools

down, then shuts down.

When the standby system is in the exercise mode, the

display console will report that, along with a countdown in

minutes of the exercise.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Rheem GEN20B Manuel de l'opérateur Page 12